Jump to content
SASS Wire Forum

Stupid question re maintenance


Cottonmouth Mark

Recommended Posts

Stupid question. I have Uberti SAA clones. 
The cross pin(?) that holds the cylinder pin/axle keeps coming loose.  Is this OK to Loctite Blue?

Link to post
Share on other sites

I did it on mine.

Link to post
Share on other sites

Try some clear fingernail polish on all your screws.  Easy to dab on, invisible, and easy to release with Acetone.

 

Ol'  #4

Link to post
Share on other sites

Locktite blue it is tomorrow.  I think the random binding I’m feeling after 50-100 rounds is that loosening up and letting the cylinder pin walk a little 

Link to post
Share on other sites
14 hours ago, Cottonmouth Mark said:

Locktite blue it is tomorrow.  I think the random binding I’m feeling after 50-100 rounds is that loosening up and letting the cylinder pin walk a little 

You are correct.  If the base pin is not fully in where it belongs the cylinder will bind.  Don't ask me how I know.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.