Worstenemy453 Posted December 1, 2020 Author Share Posted December 1, 2020 57 minutes ago, The Original Lumpy Gritz said: Were you able to open the bolt at all? Can you post a picture of the fired case? OLG I don't have it anymore. And no the rifle was completely stuck. This thing has been apart for 6 months Link to comment Share on other sites More sharing options...
Worstenemy453 Posted December 1, 2020 Author Share Posted December 1, 2020 Based on the info provided, I will re-assemble for now and try to shoot some other stuff back through it and see what happens. I will check back in as soon as I can. Thank you all for help so far. Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted December 1, 2020 Share Posted December 1, 2020 17 minutes ago, Worstenemy453 said: Based on the info provided, I will re-assemble for now and try to shoot some other stuff back through it and see what happens. I will check back in as soon as I can. Thank you all for help so far. Clean the chamber with a brass brush first. Use different ammo. You do NOT have a carrier problem. OLG Link to comment Share on other sites More sharing options...
Jackrabbit Joe #414 Posted December 1, 2020 Share Posted December 1, 2020 Sure do hope we all get an answer on what is with it all. Awaiting some answers. Worstenemy453 has got to be really frustrated over this. Everybody stand by for the next chapter & believe me this is not funny. Hope we all can help in some way. JRJ Link to comment Share on other sites More sharing options...
Worstenemy453 Posted December 2, 2020 Author Share Posted December 2, 2020 12 hours ago, Jackrabbit Joe #414 said: Sure do hope we all get an answer on what is with it all. Awaiting some answers. Worstenemy453 has got to be really frustrated over this. Everybody stand by for the next chapter & believe me this is not funny. Hope we all can help in some way. JRJ It was definitely frustrating. It was the first time I shot the gun since I bought it, and it's been in pieces ever since Link to comment Share on other sites More sharing options...
Widder, SASS #59054 Posted December 2, 2020 Share Posted December 2, 2020 Worst, The description you give is what happens when the bottom floor plate screw and the short screw on the left side of the receiver are switched.........EXCEPT you state that the rifle did cycle the 1st round. If you cycled the 1st round, then put in the wrong screw on the left side of the receiver, the rifle would do exactly as you described. Regardless, when you reassemble that rifle, note that 2 of the screws resemble each other..... BUT, the longer of those 2 screws should go in the bottom of the floor plate and the shorter screw goes on the left side of the receiver. ..........Widder Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.