Dirty Dog Doug Posted November 28, 2020 Share Posted November 28, 2020 So last year we had range office clean out, found a bunch of stuff that had been around for years I took home box of new once fired 270 brass " But you dont have a .270"... oh well it was a perfect fit just little hammering now I have tools that can lose and not worry about I can make 20 of them the one on the right is the one I got from my club made from a 30-40 krag Link to comment Share on other sites More sharing options...
Hardpan Curmudgeon SASS #8967 Posted November 28, 2020 Share Posted November 28, 2020 Sweet~! Link to comment Share on other sites More sharing options...
Dirty Dog Doug Posted November 28, 2020 Author Share Posted November 28, 2020 perfect fit I hope now I have this I will never have a stuck lifter Link to comment Share on other sites More sharing options...
Badger Mountain Charlie SASS #43172 Posted November 28, 2020 Share Posted November 28, 2020 Just now, Dirty Dog Doug said: perfect fit I hope now I have this I will never have a stuck lifter An ounce of prevention.... Link to comment Share on other sites More sharing options...
Chili Ron Posted November 29, 2020 Share Posted November 29, 2020 Howdy, If you want to get a grip just trim some skateboard tape to fit around the round. Careful with it scratching stuff of course. Best CR Link to comment Share on other sites More sharing options...
Dirty Dog Doug Posted November 29, 2020 Author Share Posted November 29, 2020 oh i learned the hard way to use lock tight on all screws my kind of fast time went bad when my lifter stuck up I had nothing to push it down To gave me his knife so I was over a minute this one is in my shotgun shell belt and i hold it stays there Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.