Jump to content
SASS Wire Forum

Pay for unpaid Carpenter .. custom cartridge screw driver


Dirty Dog Doug

Recommended Posts

Very cool!  ^_^

 

You might think about dressing the tip a mite to make it less tapered and more "parallel ground..."  Or ask your 'smith buddy to do it.  :)

Link to comment
Share on other sites

1 hour ago, Hardpan Curmudgeon SASS #8967 said:

Very cool!  ^_^

 

You might think about dressing the tip a mite to make it less tapered and more "parallel ground..."  Or ask your 'smith buddy to do it.  :)

the pic does not show it but the other side is square 

it more for a tool to push down my stuck lifter like i was looking for last Sunday  when my TO gave me his knife made loooong time 

I want to put in my gun belt but I am worried  I will take off my gun belt and it will be gone 

Link to comment
Share on other sites

What I think would be very cool would be to use a 45/70 as the parent cartridge. Then Silver solder a thin wall 6 point ¼" socket into the mouth. That way you can use any hex shank screwdriver bit you wanted. :)

Link to comment
Share on other sites

make one with 45-70 brass  I need to shorten  it a little bit 

very slippery handle 

but my gun belt has loops for 38 round ... looking for 38-55 brass now 

IMG_0536.JPG

Link to comment
Share on other sites

6 minutes ago, Dirty Dog Doug said:

make one with 45-70 brass  I need to shorten  it a little bit 

very slippery handle 

but my gun belt has loops for 38 round ... looking for 38-55 brass now 

IMG_0536.JPG

 

PM me your address and I'll send you one.  I have one with a small split in the neck you can have.

Link to comment
Share on other sites

24 minutes ago, Sedalia Dave said:

 

PM me your address and I'll send you one.  I have one with a small split in the neck you can have.

thanks I have some in my garage  just need to find the can of them 

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.