Don Jorge Posted August 4, 2020 Share Posted August 4, 2020 What might I adjust or replace on the primer system to correct an increasing number of miss-seated primers? 5-10/100 seem to be cock-eyed! Thanks. Link to comment Share on other sites More sharing options...
Fast Tracker Posted August 4, 2020 Share Posted August 4, 2020 Call Dillon. They will talk you through it. Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted August 4, 2020 Share Posted August 4, 2020 Be best to call Dillon. Good luck.... OLG Link to comment Share on other sites More sharing options...
SHOOTIN FOX Posted August 4, 2020 Share Posted August 4, 2020 That is normally a timing issue. As others have said call Dillon. Link to comment Share on other sites More sharing options...
Yusta B. Posted August 5, 2020 Share Posted August 5, 2020 Is it seating primers sideways ? Link to comment Share on other sites More sharing options...
Larsen E. Pettifogger, SASS #32933 Posted August 5, 2020 Share Posted August 5, 2020 Could be the little rubber bumper (red arrow) on the primer slide. When it deteriorates the timing goes south. Bumper is pushed onto pin. Link to comment Share on other sites More sharing options...
Larsen E. Pettifogger, SASS #32933 Posted August 5, 2020 Share Posted August 5, 2020 Just in case you do not know where this piece is located it is where the operating arm sticks into the primer slide. Red arrow. Link to comment Share on other sites More sharing options...
Don Jorge Posted August 5, 2020 Author Share Posted August 5, 2020 Thanks Larsen. I'll check that out. May need to give Dillon a call one way or the other. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.