Grizzly Dave Posted May 18, 2020 Share Posted May 18, 2020 My 1911 was too hungry for my single stage to keep up. As you might remember, I had some issues with new brass being hard to pull out of the crimp die on the single stage. I can feel it on the 650, but not nearly as much. I went with Dillon dies on the 650 for ease of cleaning especially the bullet seat die. But after trying to get a crimp I liked with the Dillon crimp die, I wound up going with the Lee Factory Crimp Die. Had to crank the die body way down to see up according to instructions, but was able to get a crimp I liked in short order after that. I got my rounds where I wanted without too much trouble, and that would pass the 'plunk' (barrel) test with no problem. Link to comment Share on other sites More sharing options...
Kulshan 20262 Posted May 18, 2020 Share Posted May 18, 2020 Nice 45 Auto. I have two of those from Ruger, like them very much. Link to comment Share on other sites More sharing options...
Chief Rick Posted May 18, 2020 Share Posted May 18, 2020 I like the Dillon dies for ease of cleaning as well, especially, like you , the seating die. If you're still getting build-up try to bell the case mouth just a little bit more. I adjusted in small increments and now rarely have a real "build-up". It also helps to go with coated bullets. Some calibers I use Lee Factory Crimp Dies, some I use the Redding Profile Dies, some I use the Dillon Crimp Dies. Link to comment Share on other sites More sharing options...
Old Man Graybeard Posted May 18, 2020 Share Posted May 18, 2020 I usually run all brass...even new ...through the vibratory with corn cob media and some of the waxy polish. Just seems like they go through the sizing die so much easier. Even with carbide dies...which is all I use on straight wall cases. Get a Bulge Buster from Lee. When you get some rounds that won't go through the go-no go gauge...run them through the bulge buster in a single stage. Works wonders. Especially since I use all range brass for 45 acp. Link to comment Share on other sites More sharing options...
Boggus Deal #64218 Posted May 18, 2020 Share Posted May 18, 2020 I use a little a Hornady One Shot lube on new brass. Works wonders! Even with carbide dies, it makes resizing so much easier on the shoulder. Link to comment Share on other sites More sharing options...
J.S. Sooner, SASS #73526 Posted May 18, 2020 Share Posted May 18, 2020 I use Hornady One Shot lube also, much easier to resize brass with it. All rounds go through a case gauge checker, this one from EGW works great. https://www.egwguns.com/ammo-chamber-checker-45-acp-7-hole Link to comment Share on other sites More sharing options...
Grizzly Dave Posted May 18, 2020 Author Share Posted May 18, 2020 I use One Shot as well on all brass Link to comment Share on other sites More sharing options...
Marauder SASS #13056 Posted May 18, 2020 Share Posted May 18, 2020 Like others have said, just a little case lube of some sort really helps my arm! (I use the homemade liquid lanolin with 99 % alcohol mix.) I figured that out when I switched from 38's over to 9mm. Now I use it for everything. Link to comment Share on other sites More sharing options...
San Joaquin Shootist Posted May 18, 2020 Share Posted May 18, 2020 Hornady One Shot gets used on all pistol loading on my bench As well. Saves a lot of elbow grease:) Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.