Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

Solomon Vaquero

Found, thanks!

Recommended Posts

Howdy pards, I am searching for squib clearing rods for rifle and pistol but have had no luck finding them. Anyone have them for sale, or can point me in the right direction? 

Share this post


Link to post
Share on other sites

Do you have a welding supply store near you.?    Good place to look   Bought 3 ft 3/8 brass rod a few tears ago.      GW

Share this post


Link to post
Share on other sites

You can find brass rod on Amazon in various lengths to work for both rifle and pistol.  .375: for 40 cal and above, .3125" for 38 SPL.   I bought brass rod at Menards while visiting the out-laws in Iowa, then cut it down for pistols.  I think TrueValue Hardware had small lengths also.

 

You can also order it from J. Hornaday Dry Goods here: J. Hornaday Squib Rods

Share this post


Link to post
Share on other sites

Buy some hardwood dowel rod just small enough to fit your barrel. Cut it into pieces, 8 inches long or so, it doesn't have to be one long piece. Easier to store that way and you can use the short piece for your pistol if needed. Just stack the pieces in your barrel and pound away!

Share this post


Link to post
Share on other sites

I build them out of brass rod and deer antler, if you’re interested I’ll send you some pictures.

Share this post


Link to post
Share on other sites

Soloman, I have them for .38 cal to .45 cal.  Scarlett , Kid Ray and others use these. Tucker T

 

Share this post


Link to post
Share on other sites

I keep a pair of Tucker T's squib rods on my cart. Top notch product.

Share this post


Link to post
Share on other sites

I’d be interested in some info on Tucker’s and Yul’s squib rods. 
TB

Share this post


Link to post
Share on other sites
17 minutes ago, TBBandito said:

I’d be interested in some info on Tucker’s and Yul’s squib rods. 
TB

PM me your email address.

Share this post


Link to post
Share on other sites
20 minutes ago, TBBandito said:

I’d be interested in some info on Tucker’s and Yul’s squib rods. 
TB

You need one of Tucker's screwdriver knives while you're at it ;)

Share this post


Link to post
Share on other sites

Hey Yul,

tried PM but won’t go thru:

 

Yul Lose cannot receive messages.

Share this post


Link to post
Share on other sites
23 minutes ago, TBBandito said:

Hey Yul,

tried PM but won’t go thru:

 

Yul Lose cannot receive messages.

Try it now.

Share this post


Link to post
Share on other sites

I made some from brass rod, on which I soldered a brass fitting for a hammering surface. One for rifle, and two sizes for handguns. They last forever.

Ironically, I've never had need for them, but helped a lot of pards clear their barrels.

Share this post


Link to post
Share on other sites

Picking up a set from Tucker T. Now I'm trying to figure out how to edit my post title to "Found them" or similar. I cannot find the edit button.. Any guidance? 

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.