Jump to content
SASS Wire Forum

Found, thanks!


Recommended Posts

Do you have a welding supply store near you.?    Good place to look   Bought 3 ft 3/8 brass rod a few tears ago.      GW

Link to comment
Share on other sites

You can find brass rod on Amazon in various lengths to work for both rifle and pistol.  .375: for 40 cal and above, .3125" for 38 SPL.   I bought brass rod at Menards while visiting the out-laws in Iowa, then cut it down for pistols.  I think TrueValue Hardware had small lengths also.

 

You can also order it from J. Hornaday Dry Goods here: J. Hornaday Squib Rods

Link to comment
Share on other sites

Buy some hardwood dowel rod just small enough to fit your barrel. Cut it into pieces, 8 inches long or so, it doesn't have to be one long piece. Easier to store that way and you can use the short piece for your pistol if needed. Just stack the pieces in your barrel and pound away!

Link to comment
Share on other sites

I build them out of brass rod and deer antler, if you’re interested I’ll send you some pictures.

Link to comment
Share on other sites

17 minutes ago, TBBandito said:

I’d be interested in some info on Tucker’s and Yul’s squib rods. 
TB

PM me your email address.

Link to comment
Share on other sites

20 minutes ago, TBBandito said:

I’d be interested in some info on Tucker’s and Yul’s squib rods. 
TB

You need one of Tucker's screwdriver knives while you're at it ;)

Link to comment
Share on other sites

23 minutes ago, TBBandito said:

Hey Yul,

tried PM but won’t go thru:

 

Yul Lose cannot receive messages.

Try it now.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.