Jump to content
SASS Wire Forum

New stock for a 16 ga Model 97 takedown


Pee Wee #15785

Recommended Posts

I have a 97 that the grand-daughter likes that the stock needs about 1 1/2" cut off for fit.  I don't want to cut the factory stock so where can a after market stock be gotten?

Link to comment
Share on other sites

Yes, as above.

 

Macon Gunstocks

34535 LICKINGTELLER AVE

WARSAW, MO 65355

PHONE: 660-438-4699

 

I have purchased 2 gunstock from them with good results.

 

Cat Brules

 

NOTE:  You may wish to see if they can sell you a (?)plastic butt plate, fitted to the butt of this new smaller stock. Your existing butt plate likely will be too large for this “cut down” buttstock you want to order.  It will save you a lot of grief.

CB

Link to comment
Share on other sites

1 hour ago, Pee Wee #15785 said:

I have a 97 that the grand-daughter likes that the stock needs about 1 1/2" cut off for fit.  I don't want to cut the factory stock so where can a after market stock be gotten?

I have a stock that has been cut down to about what you want. Make me an offer. If you PM me your email I’ll send you some pictures.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.