Earl Brasse, SASS #3562 Posted September 8, 2019 Share Posted September 8, 2019 WTB Marlin 39A Mountie Straight Butt stock & Forend for round barrel . Need the whole setup. Link to comment Share on other sites More sharing options...
Wild Willi Posted September 8, 2019 Share Posted September 8, 2019 https://www.gunbroker.com/item/821556315 Link to comment Share on other sites More sharing options...
Earl Brasse, SASS #3562 Posted September 8, 2019 Author Share Posted September 8, 2019 Thanks Wild Willi, but I need a "straight stock". Link to comment Share on other sites More sharing options...
Earl Brasse, SASS #3562 Posted September 10, 2019 Author Share Posted September 10, 2019 btt Link to comment Share on other sites More sharing options...
Earl Brasse, SASS #3562 Posted September 12, 2019 Author Share Posted September 12, 2019 btt Link to comment Share on other sites More sharing options...
Earl Brasse, SASS #3562 Posted September 14, 2019 Author Share Posted September 14, 2019 btt Link to comment Share on other sites More sharing options...
Goody, SASS #26190 Posted September 15, 2019 Share Posted September 15, 2019 I have a mountie that the stock was homemade, and very poorly. I found that with minimal work the butt stock off of a Marlin 1894 fit it. No suggestion on the fore end, but you might try it? Link to comment Share on other sites More sharing options...
Fence Cutter Posted September 15, 2019 Share Posted September 15, 2019 Have you tried Boyd's in South Dakota? I know they are closed right now due to flooding. P.S. I am a huge fan of 39 A's and own a few. good luck! Link to comment Share on other sites More sharing options...
Earl Brasse, SASS #3562 Posted September 15, 2019 Author Share Posted September 15, 2019 Goody, thanks, yes, it looks like just a little at the ends that go into the receiver will do it. Also if wanting to look "correct" cutting the comb thumb relief? cuts. Really widens the looking. I found a forend for a 39 that I think is the right one. It's on the way so I'll know soon. Fence Cutter, thanks but I'm trying to keep the costs down a bit. Link to comment Share on other sites More sharing options...
Goody, SASS #26190 Posted September 15, 2019 Share Posted September 15, 2019 When I researched for mine I found references to any modern straight stock working, so maybe a 336 as well. But I didn't have one of those so cannot confirm. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.