Jump to content
SASS Wire Forum

I’m looking for this part ...


John E.B. Rawton

Recommended Posts

I have an Uberti 1851 Man With No Name conversion in a .38. (Cimarron)

it has a rear site cut into the barrel and I need to order one. 

I have scoured the internet and reached out to Uberti but have yet to get a response. 

Anyone have any ideas?

 

F7464E2C-3D4E-40BA-A8F5-656CE624D64B.jpeg

Link to comment
Share on other sites

+1 to July.  I recall seeing some of those sights in the parts bin at Cimarron but that was a few years back.  When those guns came out, there was no rear sight (because Clint's movie gun from back then had none).  People that had them didn't miss the rear sight.  That sight gives a good sight picture but is sharp and doesn't "Look right" to me.   If I had one, I think I'd remove the rear sight and replace it with a dovetail blank.

Link to comment
Share on other sites

 “That sight gives a good sight picture but is sharp and doesn't "Look right" to me.   If I had one, I think I'd remove the rear sight and replace it with a dovetail blank.”

 

I am thinking of a blank off. It (the gun) doesn’t fit in my new holsters right. 

Link to comment
Share on other sites

“Seeing as the gun is imported by Cimarron I would give them a call first.”

 

“VTI has it listed as part number #154 and the little screw as #119”

 

I am reaching out to Cimarron. I may have misses it when I was looking on VTI. 

Thanks

Link to comment
Share on other sites

Ah. I see. Sometimes it comes down to the search phrase. I didn’t search Richards-Navy and could not pull up what I wanted. 

Thanks again. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.