Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

Subdeacon Joe

Clean Up

Recommended Posts

Deburring a machined slot .022" x .033" is a pain.

Share this post


Link to post
Share on other sites

Dental floss or toothbrush and jeweler’s rouge?

Share this post


Link to post
Share on other sites

I'm going to try using welding tip cleaners.   Note on the drawing says that the opening and the area around it needs to be smooth because a fine thread passes through it.  Also thinking of, after the deburring - material is 304 stainless - going in with pipe cleaner and rouge.

 

29 minutes ago, Pat Riot, SASS #13748 said:

 

I think that is what we used to make the slot.

Share this post


Link to post
Share on other sites

Next time have it cut with an EDM machine. Done properly the cut will have a mirror finish.

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.