Jump to content
SASS Wire Forum

Archived

This topic is now archived and is closed to further replies.

Catlow4697

38 S&W

Recommended Posts

I need the Dillon part number for converson Kit for the  XL 650 for the 38 S&W cartridge 

Yes I have checked the web sight and the blue press .

If I had  a RL 550 press I would be ok but I can't find a listing for a XL 650 or Square deal.

tried to call Dillon but was only 15 th in line. 

I tried the 38 -357 mag shell plate but the rim is to large to fit

thanks CATLOW 

Share this post


Link to post
Share on other sites

The difference appears to be 0.0075" - seven and a half thousandths of an inch, less than the thickness of two pieces of printer paper. Rim diameter is the same, so the same locating pins will work. A polishing stone in a Dremel will open them all up in just a few minutes, and it will probably still work fine for .38/.357.

38.jpg

Share this post


Link to post
Share on other sites

Thanks J BarBinks I will give it a try 

Share this post


Link to post
Share on other sites

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.