Jump to content
SASS Wire Forum

SPF.... Cimarron Open top pair


Recommended Posts

 These are Cimarron catalog # CA916 in 45 Colt with 7.5" barrels. These are not consecutively serial numbered but are 30 apart. Original boxes included.

They're not highly modified with only some tuning and barrel cylinder gaps corrected and barrel faces trued  when they were bought. I did install after market springs but experienced several FTF, so the original springs were put back in and lightened a bit. They are 100% reliable. Grips are in very good condition, no gouges or scrapes and the guns themselvesa are about 95% + condition finish. I'm turning them loose only cause I haven't used them much recently! 

I'm asking $925 shipping included to the lower 47 and California if your FFL contacts me to explain how it works in your state. 

Im adding some new photos 

PM if you need more info etc.... CC

 

 

 

 

image.jpeg

 

 

image.jpeg

image.jpeg

image.jpeg

image.jpeg

image.jpeg

Link to comment
Share on other sites

Your Killing Me ! :blush:

I already have the same guns in 44 specials all tuned up by Long Hunters Shop.

Any Ida of round count ? 

Link to comment
Share on other sites

39 minutes ago, Rooster Ron Wayne said:

Your Killing Me ! :blush:

I already have the same guns in 44 specials all tuned up by Long Hunters Shop.

Any Ida idea of round count ? 

Low round count, a few monthly matches and no big multi day shoots on them. They have been shot with BP subs and light bullets mostly.

Link to comment
Share on other sites

2 hours ago, LQ Jones said:

Army grips too - dang !!

LQ

 

They're calling you, LQ.

We'd make a pair.

Me with my .38's.

You with... Well these.

Too bad Florida is such a big state.

We might get to shoot together more often.<_<

 

Waimea

Link to comment
Share on other sites

5 hours ago, LQ Jones said:

Army grips too - dang !!

LQ

Yes they are! Very comfortable IMO.

Link to comment
Share on other sites

10 hours ago, Waimea said:

 

They're calling you, LQ.

We'd make a pair.

Me with my .38's.

You with... Well these.

Too bad Florida is such a big state.

We might get to shoot together more often.<_<

 

Waimea

Got enough room in your shop for a machine shop? I could make bullet molds for you !

Link to comment
Share on other sites

40 minutes ago, LQ Jones said:

Got enough room in your shop for a machine shop? I could make bullet molds for you !

Pm'd ya

Link to comment
Share on other sites

Has the arbor length been repaired yet ? 

Any smothing tune work done ?

Link to comment
Share on other sites

4 hours ago, Rooster Ron Wayne said:

Has the arbor length been repaired yet ? 

Any smothing tune work done ?

Like I mentioned in the OP, their cylinder barrel gaps were corrected, and one had the barrel face trued up as it was not square to the forcing cone. They have had some stone work on the hammers to remove the rough edges left over from manufacture, nothing more than that. Hope that helps..... CC :)

Link to comment
Share on other sites

BTT 

For some beautiful Open Tops ! ! ! 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.