Rancho Roy Posted May 3, 2017 Share Posted May 3, 2017 I finally finished my "Bring It Back From The Dead" 1885 Winchester . Converted from RF to CF, relined barrel and a whole bunch of other fixes. You can read all about it with tons of pictures on my web site http://rvbprecision.com Hope you like it! Link to comment Share on other sites More sharing options...
Rev. Rufus King, Esq. Posted May 3, 2017 Share Posted May 3, 2017 That was some fine work. Do you ever have any issues with the barrel liner working loose? I imagine that with a single shot rifle it will never get hot enough to release the red loctite. Link to comment Share on other sites More sharing options...
Rancho Roy Posted May 3, 2017 Author Share Posted May 3, 2017 That LocTite is designed for this type of procedure. Extreme high heat is required to break it free. Never experienced even in a black powder lever action. God help you if you ever screw one of these up and have to remove the liner. Only effective way to do it is to bore it out and start over... Link to comment Share on other sites More sharing options...
Rev. Rufus King, Esq. Posted May 3, 2017 Share Posted May 3, 2017 I've found that I can get it to break loose at around 500 degrees. My wife is not usually keen on me baking gun parts in the oven, but it works. It looks like you do some fine lathe work. That is one skill I don't have that I would very much like to learn. Link to comment Share on other sites More sharing options...
Rancho Roy Posted May 3, 2017 Author Share Posted May 3, 2017 Yup, 452 degrees will break it down. I've never even got my high rate of fire varmint rifles that hot. I wrote an article about this a number of years ago when I was active in shooting prairie dogs. We cooled the barrels by putting the muzzle in a bucket of water and drawing water into the bore with an "o" ring fitted bore cleaning rod! We were measuring temperatures and rarely got over 250 degrees. And that was with a 220 Swift. I'm sure and extreme high rate of BP shooting could get a might bit warmer. Might have to do a test someday Thanks Link to comment Share on other sites More sharing options...
Buffalo Dick, SASS #12880 Posted May 3, 2017 Share Posted May 3, 2017 For some reason the link isn't working for me. Link to comment Share on other sites More sharing options...
Garrison Joe, SASS #60708 Posted May 3, 2017 Share Posted May 3, 2017 Yeah, the link picked up part of the SASS site address. Here's all the link needs to have: http://rvbprecision.com/ Good luck, GJ Link to comment Share on other sites More sharing options...
Rancho Roy Posted May 3, 2017 Author Share Posted May 3, 2017 Link fixed.... Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted May 3, 2017 Share Posted May 3, 2017 Well done! How many hours of work do you guess you have into this? OLG Link to comment Share on other sites More sharing options...
Rancho Roy Posted May 4, 2017 Author Share Posted May 4, 2017 Only about a couple hours except for the barrel boring. At 1/8" per cut, I'm cutting, removing reamer...cleaning reamer...blowing out bore...relube vreamer...cut another 1/8"...repeat...180 TIMES! Everything else is pretty straight forward with the proper tooling. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.