Uncle Stinky Posted December 16, 2016 Share Posted December 16, 2016 The ejector on my older Navy Arms Schofield is finally too buggered up and the gun seizes when rotating 2 out of the 6. The ejector is the old style with no hole for an alignment pin that matches up to the cylinder. I've ordered a new ejector from Brownell's and Taylors and found both had the hole. They also didn't fit as the center shaft of the new ejector was 0.10mm too large to fit the hole in the cylinder. Does anyone know of a supplier that stocks the old school ejector for these older Schofields? Thanks in advance! Stinky Quote Link to comment Share on other sites More sharing options...
Larsen E. Pettifogger, SASS #32933 Posted December 16, 2016 Share Posted December 16, 2016 It is hard enough finding Uberti parts for the newer guns. Finding them for the older ones is even more difficult. I would call VTI and see if they have any old parts lying around or any suggestions. How did the old ejector get "buggered up?" Got any photos? Quote Link to comment Share on other sites More sharing options...
Uncle Stinky Posted December 16, 2016 Author Share Posted December 16, 2016 (edited) It was buggered when I bought it. I knew it was a matter of time but put it off. Thanks for the tip on VTI. No photos. It makes me cry. Edited December 16, 2016 by Uncle Stinky Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.