Dungannon Gunner Posted January 31, 2015 Share Posted January 31, 2015 A very interesting study. http://www.dayatther...m/?page_id=3667 Link to comment Share on other sites More sharing options...
Banjer Pickett Posted January 31, 2015 Share Posted January 31, 2015 VERY interesting! Good information to know. Link to comment Share on other sites More sharing options...
Sagebrush Burns, SASS # 14226 Posted January 31, 2015 Share Posted January 31, 2015 Good information - thank you. Link to comment Share on other sites More sharing options...
Blackey Cole Posted January 31, 2015 Share Posted January 31, 2015 I've been using Amsoil mp on my guns for a decade sometimes it's the noy lube the gun gets for years time. I spray my guns liberly with it after shooting when I store them back In to its sock. If it's bp I will clean asap this last time was two weeks later take out sock spray windex with viniger in bore and over gun and cylinder and one patch thru twice once each side for the bore abd one patch thru three chambers flip finish the other three then spray with mp and put in sock. Years ago it took two months to clean them and while it wasn't quite as easie the process was the same. Smokeless unless the carrier is black and sticking or their something wrong with a gun the mp shower is about it until I tear it down for some reason. The exceptions are my ROAs which get a bath in a ultra sonic cleaner minus grip panels of hot soapy water then the Amsoil shower and back to the sock. Every now and then if on of the cartridge pistols been used for bp a bunch then they might get a bath also if I remember. But the main point is the mp shower then stored in a gun sock that's was treated. Link to comment Share on other sites More sharing options...
Yellowhouse Sam # 25171 Posted January 31, 2015 Share Posted January 31, 2015 I figured eezox would do better than this!!!! Also, guess i'm living under a rock cause I didn't know there was a product named WD40 Specialist Link to comment Share on other sites More sharing options...
Church Key, SASS # 33713 Posted January 31, 2015 Share Posted January 31, 2015 I recently started using One-Shot on my Glocks. Never realized how good it is at protecting against rust. I'll try it next on a 97. Link to comment Share on other sites More sharing options...
Shorty Jack Hammer Posted January 31, 2015 Share Posted January 31, 2015 Hmmm makes feel even better about my switch to Frog Lube Link to comment Share on other sites More sharing options...
The Original Lumpy Gritz Posted January 31, 2015 Share Posted January 31, 2015 Thank you for posting this. OLG Link to comment Share on other sites More sharing options...
Wagon Box Willy Posted January 31, 2015 Share Posted January 31, 2015 I figured eezox would do better than this!!!! Also, guess i'm living under a rock cause I didn't know there was a product named WD40 Specialist It could very well be that this is an accurate test of Eezox but reading his application instructions I don't get the warm and fuzzy that he applied Eezox properly and especially that he left it wet on the metal. Link to comment Share on other sites More sharing options...
J-BAR #18287 Posted January 31, 2015 Share Posted January 31, 2015 How does Frog Lube do in black powder guns? It certainly looks good for lockworks and outside surfaces...how about inside chambers and barrels? Anyone using it in those locations? Link to comment Share on other sites More sharing options...
Buffalo Bill Mathewson, 37826 Posted January 31, 2015 Share Posted January 31, 2015 He should have been working on a gov. grant. He could have milked it for years. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.