Jump to content
SASS Wire Forum

45/70 bullet molds


Recommended Posts

been working with my rolling block all week. have my powder weight figured out. have settled on the 405g bullet sized to .458

having problem finding them or a good mold that will size and lube out to this. any recommendations will be greatly welcomed.

pm me or e-mule hrryfrdfordh@aol.com

Link to comment
Share on other sites

Well, I am going to sit down and cast some bullets this week. IF you are sold on 405 gr... I might suggest the 405 hollow base. Heck tell you what, I'll cast you up some and send them to you. now no time table heck it was 103 today in my backyard under the 80 YO pecan. at 4:00PM. BUT I'll case some and size them for you, (have to get a .458) die too, but what the heck. Muleshoe

Link to comment
Share on other sites

Precision Reloading has the Lee .459-405 mold but is out of the hollow base design. That is all I found on the sites in my Favorites folder.

Link to comment
Share on other sites

SOUTH-PACIFIC, the 405 hollow base of flat base bullet is a 200yd bullet. If you plan to shoot longer distances, recommend stepping up to a 500gr bullet. Try these bullets first and if your rifle likes them - buy the mold

* http://westernbullet.com/ly4gr10.html

* http://westernbullet.com/ly4gr11.html

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.