Butch McGie, SASS#71758 9 Posted December 13, 2011 Share Posted December 13, 2011 My neighbor gave me her fathers Hornady apex auto press. It looks hardly used. I seem to have a hard time getting the primer drop to drop a primer everytime. It works about 96% of the time -just often enuff to be frustrating, plus if that happens, it is a trip to the air compressor to blow the powder out from under the rotating mechanism. I have finally decided to deprime, size and prime then take the case out, then after I have a bunch primed then start again at the second stage and finish up. Any suggestions? Link to post Share on other sites
Abilene Slim SASS 81783 2,619 Posted December 13, 2011 Share Posted December 13, 2011 I recommend starting with Hornady Customer Support. I've found them to be very helpful. Hornady Customer Support Link to post Share on other sites
Bluestem Baldy Sass #74045 1 Posted December 13, 2011 Share Posted December 13, 2011 For me, it is a matter of being disciplined enough to pull the lever and WAIT until the primer has dropped all the way before I start to move the lever up. There is a fraction of a second delay needed. Once I get into the production mode, I tend to start to speed up. Kind of like I do with my golf swing......which is why I started cowboy action shooting. Link to post Share on other sites
Recommended Posts
Archived
This topic is now archived and is closed to further replies.