Jump to content
SASS Wire Forum

New Vaquero Bisleys .38/.357 SOLD PENDING FUNDS


Recommended Posts

SPF,, this is a pair of new Vaqueros that started life with Plow handles. I had Roughneck Rod mate a pair of thinned Bisley grips to the frame and jewel the hammer and frame. They are CONSECUTIVE serial numbers, short stroked 4 5/8 with widened sight plane. The grips are reduced by about 25% front to rear and the bottom has been reduced as well. They fit a small to medium hand really well, they are typical of what T Bone and Nuttin use. These have been fired very little. Need a new kayak so off they go

 

$1550.00 shipped to your FFL. sold only as a pair

 

http://i328.photobuc...nt/IMG_0156.jpg

http://i328.photobuc...nt/IMG_0157.jpg

http://i328.photobuc...nt/IMG_0154.jpg

http://i328.photobuc...nt/IMG_0149.jpg

http://i328.photobuc...nt/IMG_0153.jpg

http://i328.photobuc...nt/IMG_0151.jpg

Link to comment
Share on other sites

They sure are nice.

Link to comment
Share on other sites

Dirt, give me a call 406-231-2329 Shaddai

 

Shaddai, the post says the grips fit "small to medium" hands. I think you're out big boy! :lol: Nice guns Dirt.

 

Tonic

Link to comment
Share on other sites

Could you provide a few more details, may be interested in upgrading my daughter's hoglegs.....couple questions:

 

Who did the short strokes or was it a home job, and did they also remove transfer bars?

 

Any trigger work or just short-stroked?

 

Factory or aftermarket springs?

 

Any forcing cone and/or barrel crown work?

 

Do they have half cock conversions?

 

What bullet/velocity are sights regulated for?

 

 

Much Obliged,

KC

Link to comment
Share on other sites

Could you provide a few more details, may be interested in upgrading my daughter's hoglegs.....couple questions:

 

Who did the short strokes or was it a home job, and did they also remove transfer bars?

 

Any trigger work or just short-stroked?

 

Factory or aftermarket springs?

 

Any forcing cone and/or barrel crown work?

 

Do they have half cock conversions?

 

What bullet/velocity are sights regulated for?

 

 

Much Obliged,

KC

 

 

Short stroke and action job was done by Roughneck Rod a Florida gunsmith and shooter, no forcing cone or barrel crown work, Half cock, no transfer bars. triggers are set at about 2.5-3lbs. I shoot a 125tc bullet at around 850fps and they are dead on

Link to comment
Share on other sites

I bought a pair of bisley a while back,I shot them 5 from each gun. their grips were way to big for my hands shooting gunfighter.Those sure look nice and a lot smaller.Wish we were close together.Good luck with the sale.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.