Jump to content
SASS Wire Forum

Bullet mfg?


Recommended Posts

Bout a month ago or so there was a post, I think on this site, concerning a bullet mfg in the state of WA, I think it was Wa. Should have bookmarked it but I didn't. Does anyone recall this post? If so would you give me the name of the mfg again. I've already checked all the pages on this site to no avail.

Thanks

Blaze

blazeandcharmin@powerc.net

Link to post
Share on other sites

Bout a month ago or so there was a post, I think on this site, concerning a bullet mfg in the state of WA, I think it was Wa. Should have bookmarked it but I didn't. Does anyone recall this post? If so would you give me the name of the mfg again. I've already checked all the pages on this site to no avail.

Thanks

Blaze

blazeandcharmin@powerc.net

These people?

 

Desperado bullets in Dayton WA.

Link to post
Share on other sites

Thanks for the reply but it wasn't Desperado Bullets.

I think it was a new kid on the block, so to speak!

Link to post
Share on other sites

Bout a month ago or so there was a post, I think on this site, concerning a bullet mfg in the state of WA, I think it was Wa. Should have bookmarked it but I didn't. Does anyone recall this post? If so would you give me the name of the mfg again. I've already checked all the pages on this site to no avail.

Thanks

Blaze

blazeandcharmin@powerc.net

 

This one is in Oregon

 

http://www.badmanbullets.com/OnlineStore/about.php

Link to post
Share on other sites

Bout a month ago or so there was a post, I think on this site, concerning a bullet mfg in the state of WA, I think it was Wa. Should have bookmarked it but I didn't. Does anyone recall this post? If so would you give me the name of the mfg again. I've already checked all the pages on this site to no avail.

Thanks

Blaze

blazeandcharmin@powerc.net

Are you after unclad, lead bullets (like we use for CAS) or copper-plated bullets? There is a well-known vendor of plated bullets in Tacoma.

Link to post
Share on other sites

Yur thinkin' of Second Chance Bullets, out of Vancouver, WA. Run by Snappy Dan. A good Pard, and a good bullet maker too!

 

I use his .45 200 grainers, $66/1000 Contact info below:

 

http://mimamarauders.com/2ndChance.htm?bcsi-ac-07ba615bf9e246fc=1CB0A36300000105cb1R1zKumGUsXcfOAv925o3QACkZAAAABQEAAABDFwCAcAAAAQAAAIKwAAA

 

:FlagAm:

Link to post
Share on other sites

I was going to try them but it was just too much trouble to chase them down.

I'll stick with my regular guys for $2-$3 and it's a lot easier to just order on line.

Link to post
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.