Lodgekiller Posted September 5, 2011 Share Posted September 5, 2011 hammers on bakail sxs are stiff to pull back, any ideas to help make the external hammers pull easier. can't find any parts lisst online.. anybody know where to get one? Link to comment Share on other sites More sharing options...
Nate Kiowa Jones #6765 Posted September 5, 2011 Share Posted September 5, 2011 hammers on bakail sxs are stiff to pull back, any ideas to help make the external hammers pull easier. can't find any parts lisst online.. anybody know where to get one? That gun is not a typical hammer gun. It is an Anson & Deeley style boxlock converted to external hammers. The sideplate aren't even true lock plate just ornamental. Because of this conversion the hammers don't center with the bores. So, what they did was make a firing pin that looks like a crank shaft in order to line up with the primers. What that means is if you reduce the hammer spring with that much offset the gun may not be reliable. Here is a parts source and diagram; IZH43k & SPR220f This version show the cocker gun but most all of the parts are the same as the hammer version. Link to comment Share on other sites More sharing options...
WymoreWrangler SASS 46187L Posted September 5, 2011 Share Posted September 5, 2011 Trade it off and get a TTN, you will be much happier... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.