Jump to content
SASS Wire Forum

M1897 ejector spring block.

Red Cent

Recommended Posts

I have had the '97 for some time and I am finally getting around to fixing it. The problem. I believe in the original manufacturing process someone drilled the hole for this piece about 1/8" too far back. The '97 runs great. Has been tricked out by the best. But you cannot shoot a clay popper. Raise the barrel close to 45 degrees and the next round coming in will hang up with the rim between the block and the tip of the spring.

Now the question. Does anybody make a longer than spec sprimg block?

Link to post
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.