Oddnews SASS# 24779 Posted June 30, 2011 Share Posted June 30, 2011 I'm going to start off by saying that the question I'm about to ask may be very, very stupid. Will a Lyman sizing die fit into a Redding-SAECO lubrisizer? I know the nose punches will not interchange because of the screw-in design of the Redding-SAECO, but what about sizing dies? I'm soon going to have to size some .515 bullets for a .50-70, and Redding doesn't make a sizer that large. That pan lubing, which I can do, but hate doing (Or it means I buy a Lyman, but gee, too lubrisizers has to be excessive). Anyway, inquiring half-wits (me) want to know. Link to comment Share on other sites More sharing options...
Jefro, SASS#69420 Posted June 30, 2011 Share Posted June 30, 2011 Check over at Cast Boolits for a feller named Lathesmith, he may be able fix you up if you can't find what you need. He's done a couple for my Stars, very nice. Good Luck Lathesmith Jefro Relax-Enjoy Link to comment Share on other sites More sharing options...
August West, SASS #45079 Posted June 30, 2011 Share Posted June 30, 2011 No. RCBS and Lyman will interchange. Neither Lyman, nor RCBS are compatible with Saeco. Link to comment Share on other sites More sharing options...
Oddnews SASS# 24779 Posted June 30, 2011 Author Share Posted June 30, 2011 That's what I was afraid of. I'll check out the Lathesmith guy (and then probably go buy a Lyman, anyway, dangit). Link to comment Share on other sites More sharing options...
Cusz M. Dutch SASS Life 55326 Posted June 30, 2011 Share Posted June 30, 2011 A local machine shop should be able to fix you up for a lot less than a new sizer. Just take them in a die that fits and give them the diameter of what you need. Link to comment Share on other sites More sharing options...
Bottom Dealin Mike, SASS #22273 Posted July 1, 2011 Share Posted July 1, 2011 Oddnews, Who says two lubrisizers is excessive? I have a 450 for black powder lube and a 4500 for smokeless lube. Link to comment Share on other sites More sharing options...
Dick Dastardly SASS #45219 Posted July 2, 2011 Share Posted July 2, 2011 Another vote here for Lathesmith. Chris made me some dies and they are absolutely tops. DD-DLoS Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.