Little Roundman, SASS #72001 Posted December 6, 2010 Share Posted December 6, 2010 Pards, I need your help again. I'm looking at a used Cimmaron, Uberti, Lightning. The barrel is marked .38 Colt & .38 S&W. BUT, under the ejector rod shroud it is clearly stamped .38 Spec. The ejector and shroud must be removed before the cylinder can be removed for cleaning or the .38 Spec would not be visable. Is this revolver safe to fire with .38 Spec. cowboy smokless or black powder loads? The .38 specials fit the cylinder, but that doesn't make it safe. Your help is greatly appreciated. Little Roundman SASS 72001 Link to comment Share on other sites More sharing options...
Goody, SASS #26190 Posted December 6, 2010 Share Posted December 6, 2010 Perfectly fine with any SAAMI spec 38 special load. Link to comment Share on other sites More sharing options...
Jefro, SASS#69420 Posted December 6, 2010 Share Posted December 6, 2010 Yes they are made for the 38sp. You don't have to remove the ejector housing to remove the cylinder, push the ejector rod down while at the same time remove the base pin. At first you'll think you need three hands, but with a little practice it's very easy. Godd Luck. Jefro Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.