Come On Christmas Posted December 2, 2010 Share Posted December 2, 2010 I was looking through Brownwells and they don't have a lot of pictures of them. Does anyone have brass one that they have used they really like what are legal for SASS? Shameless Link to comment Share on other sites More sharing options...
Smithy Posted December 2, 2010 Share Posted December 2, 2010 It all depends on what you are after. If you are like me (and my eyesight) where bigger is better, then I would suggest getting Brownells biggest brass bead. But, if you are also trying to match threads of your existing bead you may be headed for some trouble as Brownells are all US threads and most of the import copies are either metric or worse as in my case staked. That is another plus to going to the largest bead because you just also buy the corresponding tap, remove the old bead and tap the new threads and you are good to go. Smithy. Link to comment Share on other sites More sharing options...
Come On Christmas Posted December 2, 2010 Author Share Posted December 2, 2010 This bead will be for an amputation of a Winchester 1897. Link to comment Share on other sites More sharing options...
Captain Woodrow Cahill, SASS # 54363 Posted December 2, 2010 Share Posted December 2, 2010 Drill and tap here .... http://www.midwayusa.com/viewproduct/?productnumber=293476 Beads here .... http://www.midwayusa.com/Search/#shotgun bead 6-48____-_1-2-4_8-16-32 If you've not already cut down the barrel, use the current front bead as a guide point to find the TDC of the barrel to mark where you intend to put the new one. A piece of fishing line tied around the bead and stretched to the center of the receiver will be the most accurate way. Link to comment Share on other sites More sharing options...
Colorado Coffinmaker Posted December 2, 2010 Share Posted December 2, 2010 I personally prefer a front bead that resembles a doorknob. A bead about .175 Coffinmaker Link to comment Share on other sites More sharing options...
Gunslinger SASS 10706 Life Posted December 2, 2010 Share Posted December 2, 2010 Get the # 4 from Brownell's, requires 6-48 tap. I use that size for 97's and SxS. Link to comment Share on other sites More sharing options...
Kulshan 20262 Posted December 3, 2010 Share Posted December 3, 2010 +1 on the #4. Link to comment Share on other sites More sharing options...
I. M. Crossdraw, SASS# 8321 Posted December 3, 2010 Share Posted December 3, 2010 Use #4 size bead (.175 dia.) brass with shaft/thread size 6-48, Brownells item # 080-532-132 Use drill size #31 Tap size 6-48 Hope this help. I.M. Crossdraw Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.